February 2020 – TD 266 OPERATING MANUAL – ZPulse® DCS 4420/4830/4520/4930 Page 81
When you select User Maintenance you will first enter a window with a
Run Wizard button on the top and then two tabs named Instrument and
Sensors.
To configure the DCS you might either select the Run Wizard button and
then step trough all the User Maintenance settings until you reach the
DCS settings our you might select the Sensors tab
Under the Sensor tab you will find a list of all available sensors.
Figure 5-13: User Maintenance
Select the Senor tab and then the DCS before ticking the Configure
button
Figure 5-14: User Maintenance DCS
To Next Page
Loading...