Section 5 TLL Displays Faceplates for Program Elements
3BUR002418-600 A 107
To change AC, you must first put the I/O point into a forced state by clicking on the
Forced YES button. Then you can change the status between ON and OFF or
OPEN and CLOSED. When a point is forced, it affects the value in the segment
only. The actual condition of the point in the field is not affected.
The character F is used to indicate all points that are forced, Figure 45. Forcing is
also supported via the I/O Point Display. For more information, refer to I/O Point
Display on page 115.
TLL Timer Faceplate
You can change the Preset, Value, and Enable in the TLL Timer faceplate. The
format for Preset and Value time entries is described in Timer Display on page 112.
TLL Counter Faceplate
You can change the Preset, Value, and Enable in the TLL Counter faceplate. For
more information on the TLL Counter faceplate, refer to Counter Display on page
110.
TLL Register Faceplate
You can change the Value in the TLL Register faceplate. For more information on
the TLL Register faceplate, refer to Register Display on page 108.
Figure 45. Indication of a Forced Point
To Next Page
Loading...
