ABB 800xA - Page 55

Section 3 CCF Displays Engineer Tuning Displays for a Continuous Loop
3BUR002418-600 A 55
To support Loop FCM Display functions, the following buttons are provided:
LOOP TMPL This button accesses the runtime version of the Loop Definition
Templet. Figure 15 shows a typical MOD Loop Definition
Templet. See Appendix A, Runtime Templates for a description
of the active runtime fields.
FCM TMPL This button accesses the runtime versions of the FCM templets
for the loop. A FCM must be selected to see this button (See
LINEAR TBL if a TABL FCM is selected). Double click on the
FCM block also accesses the FCM Templet. See the
Configurable Control Functions (CCF) User’s Guide for a
DETAILED description of the fields on the Loop FCM Templets.
See Appendix A, Runtime Templates for a description of the
active runtime fields.
LINEAR TBL This button accesses the runtime version of a Breakpoint Sets
Templet (Linearization Update Display) for a selected TABL
FCM. The NAME OF SET is displayed but can not be changed.
Up to 11 X, Y Value pairs can be configured into the breakpoint
table from this display. Valid entry is a floating point number.
See Runtime Version of Breakpoint Sets Templet on page 57.