ABB ACS880 N5700 Series - Page 178

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
10 = 1 s / 10 = 1 sActivation delay for RO1.0.0 ... 3000.0 s
0.0 s / uint32Defines the deactivation delay for relay output RO1.
See parameter 10.25 RO1 ON delay.
RO1 OFF delay10.26
10 = 1 s / 10 = 1 sDeactivation delay for RO1.0.0 ... 3000.0 s
Running (95.20 b3) /
uint32
Selects a drive signal to be connected to relay output
RO2.
For the available selections, see parameter 10.24 RO1
source.
RO2 source10.27
0.0 (95.20 b3) s /
uint32
Defines the activation delay for relay output RO2.
Status of selected
source
RO status
t
On
t
Off
t
Off
t
On
1
0
0
1
Time
t
On
= 10.28 RO2 ON delay
t
Off
= 10.29 RO2 OFF delay
RO2 ON delay10.28
10 = 1 s / 10 = 1 sActivation delay for RO2.0.0 ... 3000.0 s
0.0 (95.20 b3) s /
uint32
Defines the deactivation delay for relay output RO2.
See parameter 10.28 RO2 ON delay.
RO2 OFF delay10.29
10 = 1 s / 10 = 1 sDeactivation delay for RO2.0.0 ... 3000.0 s
Fault (-1) / uint32Selects a drive signal to be connected to relay output
RO3.
For the available selections, see parameter 10.24 RO1
source.
RO3 source10.30
0.0 s / uint32Defines the activation delay for relay output RO3.
Status of selected
source
RO status
Time
1
0
1
0
t
On
t
On
t
Off
t
Off
t
On
= 10.31 RO3 ON delay
t
Off
= 10.32 RO3 OFF delay
RO3 ON delay10.31
10 = 1 s / 10 = 1 sActivation delay for RO3.0.0 ... 3000.0 s
0.0 s / uint32Defines the deactivation delay for relay output RO3.
See parameter 10.31 RO3 ON delay.
RO3 OFF delay10.32
10 = 1 s / 10 = 1 sDeactivation delay for RO3.0.0 ... 3000.0 s
10.0 ms / uint32Defines a filtering time for parameters 10.1 DI status
and 10.2 DI delayed status.
DI filter time10.51
10 = 1 ms / 10 = 1 msFiltering time for 10.1 and 10.2.0.3 ... 100.0 ms
178 Parameters