ABB ACS880 N5700 Series - Page 327

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1 = 10000h…FFFFh
0.00 A / real32Sets a custom motor current fault limit.
The drive automatically sets an internal motor current
limit according to the drive hardware. The internal limit
is appropriate in most cases, but this parameter can
be used to set a lower current limit, for example, to
protect a permanent magnet motor from
demagnetization.
Note: The limit defines the maximum peak current of
one phase.
With this parameter at 0.0 A, only the internal limit is
in force.
Overcurrent fault
limit
31.42
- / -Custom motor current fault limit. For scaling, see
parameter 46.5.
0.00 ... 30000.00 A
Coast / uint16Selects the stop mode when a non-critical fault occurs.Fault action31.54
0The drive coasts to a stop.Coast
1The drive follows the ramp specified for an emergency
stop in parameter 23.23 Emergency stop time.
Emergency ramp
Fault / uint16Selects how the drive reacts when the communication
to an I/O extension module fails.
Ext I/O comm loss
event
31.55
0No action taken.No action
1The drive generates a warning, A799 ExtIO comm loss.Warning
2The drive trips on a fault, 7082 Ext I/O comm loss.Fault
Fault / uint16 (Only visible when IGBT supply unit control activated
by 95.20 )
Selects how the supply unit reacts when an earth fault
or current unbalance is detected.
LSU earth fault31.120
0No action taken.No action
1The supply unit generates a warning,Warning
2The supply unit trips on a fault, 2E01 Earth leakage.Fault
Fault / uint16 (Only visible when IGBT supply unit control activated
by 95.20 )
Selects how the supply unit reacts when a supply phase
loss is detected.
LSU supply phase
loss
31.121
0No action taken.No action
1The supply unit trips on a fault, 3E00 Input phase loss.Fault
Parameters 327