Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
71.11 DC voltage (page 135).DC voltage
81.14 Output power (page 135).Power inu out
1023.1 Speed ref ramp input (page 270).Speed ref ramp in
1123.2 Speed ref ramp output (page 270).Speed ref ramp out
1224.1 Used speed reference (page 277).Speed ref used
1326.2 Torque reference used (page 297).Torq ref used
See Terms and abbreviations (page 130).Other [value]
201.70 Ambient temperature % (page 137).
The amplitude range of 0…100% corresponds to
0…60 °C or 32…140 °F.
Ambient
temperature
100.00 / real32Defines the signal value that corresponds to 100%
amplitude.
AL2 signal scaling36.7
1 = 1 / 100 = 1Signal value corresponding to 100%.0.00 ... 32767.00
- / uint16Determines whether amplitude loggers 1 and 2 are
active continuously or only when the drive is
modulating.
Logger function36.8
0 = Amplitude logger 1 active continuously
1 = Amplitude logger 1 active only when the drive is
modulating
AL1b0
0 = Amplitude logger 2 active continuously
1 = Amplitude logger 2 active only when the drive is
modulating
AL2b1
Reservedb2…15
1 = 10000h…FFFFh
Done / uint16Resets the peak value logger and/or amplitude logger
2.
(Amplitude logger 1 cannot be reset.)
Reset loggers36.9
0Reset completed or not requested (normal operation).Done
1Reset both the peak value logger and amplitude logger
2.
All
2Reset the peak value logger.PVL
3Reset amplitude logger 2.AL2
- / real32Displays the peak value recorded by the peak value
logger.
PVL peak value36.10
1 = 1 / 100 = 1Peak value.-32768.00 ...
32767.00
0 / uint16Displays the date on which the peak value was
recorded.
PVL peak date36.11
0 / uint32Displays the time at which the peak value was recorded.PVL peak time36.12
1 = 1Peak occurrence time.00:00:00…23:59:59
- / real32Displays the motor current at the moment the peak
value was recorded.
PVL current at peak36.13
356 Parameters
To Next Page
Loading...
