ABB ACS880 N5700 Series - Page 524

Def / Type
FbEq 16b / 32b
DescriptionName / Range /
Selection
No.
1 = Set: Copy value of 96.53 into 96.57.Set approved
checksum 2
b5
1 = Set: Copy value of 96.53 into 96.58.Set approved
checksum 3
b6
1 = Set: Copy value of 96.53 into 96.59.Set approved
checksum 4
b7
Reservedb8…15
1 = 10000h…FFFFh
0 / uint32Approved (reference) checksum 1.Approved checksum
1
96.56
1 = 1Approved checksum 1.00000000…FFFFFFFFh
0 / uint32Approved (reference) checksum 2.Approved checksum
2
96.57
1 = 1Approved checksum 2.00000000…FFFFFFFFh
0 / uint32Approved (reference) checksum 3.Approved checksum
3
96.58
1 = 1Approved checksum 3.00000000…FFFFFFFFh
0 / uint32Approved (reference) checksum 4.Approved checksum
4
96.59
1 = 1Approved checksum 4.00000000…FFFFFFFFh
- / uint16Provides status information on the user data logger.
See section Warning/fault history and
analysis (page 548).
Note: This parameter is read-only.
User data logger
status word
96.61
1 = The user data logger is running. The bit is cleared
after the post-trigger time has passed.
Runningb0
1 = The user data logger has been triggered. The bit is
cleared when the logger is restarted.
Triggeredb1
1 = The user data logger contains data that can be read.
Note that the bit is not cleared because the data is
saved to the memory unit.
Data availableb2
1 = The user data logger has been configured. Note that
the bit is not cleared because the configuration data
is saved to the memory unit.
Configuredb3
Reservedb4…15
1 = 10000h…FFFFh
Off / uint32Triggers, or selects a source that triggers, the user data
logger.
User data logger
trigger
96.63
00.Off
11.On
See Terms and abbreviations (page 130).Other [bit]
Off / uint32Starts, or selects a source that starts, the user data
logger.
User data logger
start
96.64
524 Parameters