ABB ACSM1 - Page 114

Parameters and firmware blocks
114
8.06 ALARM LOGGER 2 FW block: FAULT FUNCTIONS (page 196)
Alarm logger 2. For possible causes and remedies, see chapter Fault tracing. Can be reset by
entering a 0.
8.07 ALARM LOGGER 3 FW block: FAULT FUNCTIONS (page 196)
Alarm logger 3. For possible causes and remedies, see chapter Fault tracing. Can be reset by
entering a 0.
Bit Alarm
0 IGBT OVERTEMP
1 FIELDBUS COMM
2 LOCAL CTRL LOSS
3 AI SUPERVISION
4 Reserved
5 NO MOTOR DATA
6 ENCODER 1 FAIL
7 ENCODER 2 FAIL
8 LATCH POS 1 FAIL
9 LATCH POS 2 FAIL
10 ENC EMUL FAILURE
11 FEN TEMP FAILURE
12 ENC MAX FREQ
13 ENC REF ERROR
14 RESOLVER ERR
15 ENCODER 1 CABLE
Bit Alarm
0 ENCODER 2 CABLE
1D2D COMM
2 D2D BUF OVLOAD
3 PS COMM
4 RESTORE
5 CUR MEAS CALIB
6 AUTOPHASING
7 EARTH FAULT
8 Reserved
9 MOTOR NOM VALUE
10 D2D CONFIG
11 STALL
12…14 Reserved
15 SPEED FEEDBACK