ABB ACSM1 - Page 115

Parameters and firmware blocks
115
8.08 ALARM LOGGER 4 FW block: FAULT FUNCTIONS (page 196)
Alarm logger 4. For possible causes and remedies, see chapter Fault tracing. Can be reset by
entering a 0.
8.09 ALARM LOGGER 5 FW block: FAULT FUNCTIONS (page 196)
Alarm logger 5. For possible causes and remedies, see chapter Fault tracing. Can be reset by
entering a 0.
8.10 ALARM LOGGER 6 FW block: FAULT FUNCTIONS (page 196)
Alarm logger 6. For possible causes and remedies, see chapter Fault tracing. Can be reset by
entering a 0.
Bit Alarm
0 OPTION COMM LOSS
1 SOLUTION ALARM
2…5 Reserved
6 PROT. SET PASS
7…8 Reserved
9 DC NOT CHARGED
10 SPEED TUNE FAIL
11…15 Reserved
Bit Alarm
0…15 Reserved
Bit Alarm
0…1 Reserved
2 LOW VOLT MOD CON
3…15 Reserved