ABB ACSM1 - Page 117

Parameters and firmware blocks
117
8.17 ALARM WORD 3 FW block: FAULT FUNCTIONS (page 196)
Alarm word 3. For possible causes and remedies, see chapter Fault tracing. This alarm word is
refreshed, ie, when the alarm goes off, the corresponding alarm bit is cleared from the signal.
8.18 ALARM WORD 4 FW block: FAULT FUNCTIONS (page 196)
Alarm word 4. For possible causes and remedies, see chapter Fault tracing. This alarm word is
refreshed, ie, when the alarm goes off, the corresponding alarm bit is cleared from the signal.
Bit Alarm
0 ENCODER 2 CABLE
1D2D COMM
2 D2D BUF OVLOAD
3 PS COMM
4 RESTORE
5 CUR MEAS CALIB
6 AUTOPHASING
7 EARTH FAULT
8 Reserved
9 MOTOR NOM VALUE
10 D2D CONFIG
11 STALL
12…14 Reserved
15 SPEED FEEDBACK
Bit Alarm
0 OPTION COMM LOSS
1 SOLUTION ALARM
2…5 Reserved
6 PROT. SET PASS
7…8 Reserved
9 DC NOT CHARGED
10 SPEED TUNE FAIL
11…15 Reserved