ABB ACSM1 - Page 325

Fault tracing
325
0067 FPGA ERROR1
(0x5401)
Drive internal fault Contact your local ABB representative.
0068 FPGA ERROR2
(0x5402)
Drive internal fault Contact your local ABB representative.
0069 ADC ERROR
(0x5403)
Drive internal fault Contact your local ABB representative.
0073 ENC 1 PULSE
FREQUENCY
(0x738B)
Encoder 1 is receiving too high
data flow (pulse frequency).
Check encoder settings.
Change parameters 93.03 ENC1 SP
CALCMODE and 93.13 ENC2 SP
CALCMODE to use only one channel pulses/
edges.
0074 ENC 2 PULSE
FREQUENCY
(0x738C)
Encoder 2 is receiving too high
data flow (pulse frequency).
Check encoder settings.
Change parameters 93.03 ENC1 SP
CALCMODE and 93.13 ENC2 SP
CALCMODE to use only one channel pulses/
edges.
0075 MOT OVERFREQUENCY
(0x7390)
Inverter output (motor)
frequency has exceeded the
frequency limit 599 Hz.
Reduce the motor rotation speed.
0201 T2 OVERLOAD
(0x0201)
Firmware time level 2 overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0202 T3 OVERLOAD
(0x6100)
Firmware time level 3 overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0203 T4 OVERLOAD
(0x6100)
Firmware time level 4 overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0204 T5 OVERLOAD
(0x6100)
Firmware time level 5 overload
Note: This fault cannot be
reset.
Contact your local ABB representative.
0205 A1 OVERLOAD
(0x6100)
Application time level 1 fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0206 A2 OVERLOAD
(0x6100)
Application time level 2 fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
0207 A1 INIT FAULT
(0x6100)
Application task creation fault
Note: This fault cannot be
reset.
Contact your local ABB representative.
Code Fault
(fieldbus code)
Cause What to do