ABB Advant Controller 450 User Manual

Advant
®
Controller 450 User’s Guide
Table of Contents
3BSE 002 415R701 Rev A xiii
Figure 2-21. Supply of Peripheral Unit without Modem................................................ 2-39
Figure 2-22. Short Distance Connection of Printer......................................................... 2-40
Figure 2-23. Long-distance Connection of Printer.......................................................... 2-41
Figure 2-24. Connections and Grounding of Communication Cable Shields................. 2-41
Figure 2-25. Power-up, Circuit Breakers and Positive Indications................................. 2-56
Figure 2-26. Controller System Configuration in a Broad Outline................................. 2-58
Figure 2-27. “Modify Permission” in a Control Module................................................ 2-70
Figure 2-28. Principal Block Diagram of S100 I/O Input Channel, Test Points............. 2-74
Figure 2-29. Principal Block Diagram of S100 I/O Output Channel, Test Points.......... 2-76
Figure 2-30. Graphic Diagram ........................................................................................ 2-78
Figure 2-31. Program List............................................................................................... 2-78
Figure 2-32. Grounding of Connection Units ................................................................. 2-84
Figure 2-33. I/O Subrack................................................................................................. 2-85
Figure 3-1. External Synchronization of System Clock.................................................. 3-2
Figure 3-2. Run/Alarm Relay Connection ...................................................................... 3-2
Figure 3-3. Connection of Additional Supervisory Inputs.............................................. 3-3
Figure 3-4. Power Supply Terminal Settings .................................................................. 3-3
Figure 3-5. Examples of Distribution Board Fusing, d.c................................................ 3-9
Figure 3-6. Reduction Factors for Cabinets Installed in Groups................................... 3-33
Figure 3-7. Advant Controller 450 Priority System...................................................... 3-40
Figure 3-8. CPU Load Calculation Methods................................................................. 3-42
Figure 3-9. Load from Cyclic Functions, Overview..................................................... 3-45
Figure 3-10. Load Caused by Subscription..................................................................... 3-50
Figure 3-11. Load Caused by Sending Data Set (MasterBus 300) ................................. 3-51
Figure 3-12. Load Caused by Receiving Data Set (MasterBus 300).............................. 3-52
Figure 3-13. Load Caused by a MasterView 320............................................................ 3-52
Figure 3-14. Load Caused by a Log (Short Intervals)..................................................... 3-53
Figure 3-15. Load Caused by a Log (Medium Intervals)................................................ 3-54
Figure 3-16. Load Caused by DSP with Advant Fieldbus 100,
Basic Cycle Time 32 ms............................................................................. 3-55
Figure 3-17. Load Caused by DSP with Advant Fieldbus 100,
Basic Cycle Time 512 ms........................................................................... 3-55
Figure 3-18. Load Caused by EXCOM, 1200 bit/sec..................................................... 3-56
Figure 3-19. Load Caused by EXCOM, 9600 bit/sec..................................................... 3-57
Figure 3-20. Load Caused by EXCOM, 19200 bit/sec................................................... 3-57
Figure 3-21. Structuring Limits....................................................................................... 3-68
Figure 3-22. Example of Designations in a Feedback Control Loop.............................. 3-74
Figure 4-1. Start Mode Selector...................................................................................... 4-2
Figure 4-2. First Power-up.............................................................................................. 4-5
Figure 4-3. Power-up of Controller which Contains Application................................... 4-6

ABB Advant Controller 450 Specifications

General

Brand	ABB
Model	Advant Controller 450
Category	Controller
Language	English