ABB DCS550 - Page 149

149
Winder
3ADW000379R0501 DCS550 Manual e e
These values are determined by WindUnwindCmd (61.04) and TopBottomCmd (61.05):
①, ①b
②, ②b
③, ③b
④, ④b
WindUnwindCmd (61.04) =
Winder
Unwinder
Winder
Unwinder
TopBottomCmd (61.05) =
Top
Top
Bottom
Bottom
n
Torque
* = Direction of speed with command winder on, see
MotSpeed (1.04)
+
-
-
+
T
Tension
** = Direction of torque for tension, see TensToTorq
(63.24)
+
+
-
-
T
Acceleration
* = Direction of torque for acceleration, see
InertiaComp (62.30)
+
-
-
+
T
Decleration
* = Direction of torque for deceleration, see
InertiaComp (62.30)
-
+
+
-
T
Inertia
* = Direction of torque for inertia compensation, see
InertiaComp (62.30)
+
-
-
+
T
Friction
* = Direction of torque for friction compensation, see
FrictionComp (63.34)
+
-
-
+
n
0
** = Speed offset used e.g. for indirect tension control,
see WindSpdOffset (61.14). Always use a positive value!
+10 %
+10 %
-10 %
-10 %
* Depending on setting of WindUnwindCmd (61.04) and TopBottomCmd (61.05)
** Depending on setting of TopBottomCmd (61.05)