NoteEquipment
Content is defined in section Standard tools
on page 393.
Standard toolkit
Additional equipment - Foundry Prime
NoteArt. no.Equipment
Mercasol3HAC034903-001Rust preventive
3HAC026759-001Sikaflex 521FC
12340011-116Loctite 574
Brush
3HAC035355-001Foundry Prime touch up kit
CAUTION
Always cut the paint with a knife and grind the paint edge when disassembling
parts. See Cut the paint or surface on the robot before replacing parts on page 201.
Draining, axis-3 gearbox
Use this procedure to drain the gearbox of oil.
There is an alternative method to drain the gearbox. See Draining - alternative
method on page 173.
NoteAction
xx0800000327
Move the robot to an upright position as shown
in the figure.
1
• A: Oil collecting vessel
Continues on next page
172 Product manual - IRB 4600 Foundry Prime
3HAC040585-001 Revision: M
© Copyright 2013-2018 ABB. All rights reserved.
3 Maintenance
3.5.5 Changing the oil, axis-3 gearbox
Continued
To Next Page
Loading...
