7.8 HILTI adhesive anchor
Overview
xx1400000489
Basic data (for a single anchor)
All data in this section applies to:
• Correct setting (See setting instruction)
• No edge distance and spacing influence
• Steel failure
• Base material thickness, as specified in the table
• One typical embedment depth, as specified in the table
• One anchor material, as specified in the tables
• Concrete C 20/25, fck,cube = 25 N/mm²
• Temperate range I (min. base material temperature -40°C, max. long
term/short term base material temperature: +24°C/40°C)
• Installation temperature range -5°C to +40°C
M16 anchor
125Typical embedment depth [mm]
i
210Base material thickness [mm]
5.8Carbon steel, strength class
75,6Mean ultimate resistance:concrete C 20/25 – fck,cube = 25 N/mm², anchor HAS
Tensile NRu,m HAS [kN]
37,8Mean ultimate resistance:concrete C 20/25 – fck,cube = 25 N/mm², anchor HAS
Shear VRu,m HAS [kN]
60,0Characteristic resistance: concrete C 20/25 – fck,cube = 25 N/mm², anchor HAS
Tensile NRk HAS [kN]
36,0Design resistance: concrete C 20/25 – fck,cube = 25 N/mm², anchor HAS
Shear VRk HAS [kN]
40,0Recommended loads
ii
: concrete C 20/25 – fck,cube = 25 N/mm², anchor HAS
Tensile NRd HAS [kN]
Continues on next page
Product manual - IRBT 2005 279
3HAC051130-001 Revision: F
© Copyright 2015 - 2018 ABB. All rights reserved.
7 Reference information
7.8 HILTI adhesive anchor
To Next Page
Loading...
