4.5 Replacing the mechanical stops
Location of mechanical stops
The mechanical stops are located at both end of the track. Two mechanical stops
are used on each side of the track end to buffer the impact from the carriage if the
carriage moves outside of the software limit of the track.
xx1400000499
Mechanical stops, leftA
Mechanical stops, rightB
Required equipment
NoteEquipment
Spare part number is specified in Spare parts
on page 283.
Mechanical stops
The content is defined in Standard tools on
page 276.
Standard toolkit
Continues on next page
190 Product manual - IRBT 2005
3HAC051130-001 Revision: F
© Copyright 2015 - 2018 ABB. All rights reserved.
4 Repair
4.5 Replacing the mechanical stops
To Next Page
Loading...
