2.4.6 Positioning the stand
Positioning the stands
Illustration/NoteAction
xx1400001410
Position the sections in the intended work
site. If more than one section is used, as-
semble them as described in Assembling
the sections of the track motion IRBT 2005
(Longer than 9 m) on page 83.
1
xx1400000463
A Leveling screw
Adjust the horizontality of the IRBT 2005
with the M60 leveling screw using the lev-
eling tool (Art. No. 3HAC054535-001).
2
Make sure that all the leveling screws are
touching the floor.
3
xx1400000464
A Fitting nut
Tighten the M60 fitting nuts using the nut
adjustment tool (Art. No. 3HAC054534-001).
4
Continues on next page
92 Product manual - IRBT 2005
3HAC051130-001 Revision: F
© Copyright 2015 - 2018 ABB. All rights reserved.
2 Installation and commissioning
2.4.6 Positioning the stand
To Next Page
Loading...
