Two holes at each side of the carriage table, circled in the following figure, are
available for ground cables.
xx1500001610
Transfer carriage table
The figure below shows the dimensions of the transfer carriage table in mm.
Eight M10 holes circled in the following figure are available for fastening the fixture
on the carriage.
xx1400001407
Continues on next page
Product manual - IRBT 2005 75
3HAC051130-001 Revision: F
© Copyright 2015 - 2018 ABB. All rights reserved.
2 Installation and commissioning
2.3.6 Measures of the carriage table
Continued
To Next Page
Loading...
