8: RFC-2544
Mbps and 980 Mbps (for a Step size of 20 Mbps). Both tests must yield no frame loss to be successful, or a lower rate will
then be tested.
Trial duration
The Trial duration is the duration for which the test will be run.
Step size
The Step size defines the granularity of the range.
Back to back settings
The Back-to-back test performs a burst for a duration of time. The NID will again perform a Back-to-back test for each one
of the Frame sizes selected. To be successful, the DUT must not create any frame loss for each burst. A burst will have a
duration specified by the Total duration parameter, and the NID will perform a number of bursts as defined by the Repeat
parameter. A pause of 2 seconds will be done after each burst.
Trial duration
The Trial duration is the duration for which the test will be run in milli-secs.
Repeat
Indicates the number of bursts perform for each packet size.
To Next Page
Loading...
