Accedian EtherNID EE - Resetting to Factory Defaults

2: Hardware Installation
Restarting
To restart the EtherNID:
1. Press and hold the Bypass button.
2. Press and release the Loopback button. The unit will restart.
3. Release the Bypass button.
If required, the EtherNID can also be restarted using the command line interface. See Chapter 12 for details.
Resetting to factory defaults
To reset the EtherNID to factory default settings:
1. Press and hold the Bypass button.
2. Press and release the Loopback button.
3. Continue to press the Bypass button until the following lights all flash at the same time:
Minor
Major
Critical
Power
4. Release the Bypass button.