3: Management & Configuration
Date and time settings
NTP enable
Enable this option to set the system time automatically by polling an NTP server. Select a server from the list or add your
own.
NTP server enable
Enable this option to start the NTP server service.
High resolution sync
Enable this option to use high resolution hardware synchronization. In this mode, the NTP server is queried multiple times
and the resulting time is derived from an averaging process based on a hardware clock. If unchecked, the NTP server is
only queried every 30 minutes and the system time is set accordingly, without further processing.
TAI offset
Offset to add to UTC time to convert to Temps Atomique International (Atomic International Time).
DSCP
When using NTP, the priority can be set in the DiffServ Code Point.
VLAN priority
When using NTP, the priority of the packets can be set in the VLAN priority bits if the link is through a VLAN.
Date and Time
If not using NTP you can set the date and time manually.
To Next Page
Loading...
