3: Management & Configuration
Beacon settings
State
Enable or disable the transmission of beacon frames on the interface. This is disabled by default.
Beacon rate
Used to select at which time interval the beacon frames will be sent.
Domain ID
The domain ID that will be used in the discovery process. The domain ID can be matched by remote devices to select
which beacons it should process.
IP config mode
Used to select the IP configuration mode that should be used by the receiver.
• Local: Use the remote device interface settings.
• Auto: Tell the remote device to compute an IP address, given the subnet, gateway and mask.
• Auto static: Behaves like Auto, but preserves the IP address, gateway and mask if an IP is already configured
(different than 0.0.0.0)
• DHCP: Use DHCP to get an IP address for the interface.
IP subnet
The subnet to be used by the remote device when the Auto IP configuration mode is selected.
Mask
The mask to be used by the remote device when the Auto IP configuration mode is selected.
Gateway
The gateway to be used by the remote device when the Auto IP configuration mode is selected.
Authorize ID mismatch
When enabled, it tells the receiver to accept beacons even if the beacon's domain ID does not match the local domain ID.
To Next Page
Loading...
