3: Management & Configuration
SNMP trap receivers parameters
Type
Type of SNMP Trap receivers. SNMPv1 / SNMPv2c
ID
ID number of the trap receiver.
State
If Enabled the unit will send SNMPv1 or SNMPv2c traps to a specified notification receiver.
UDP port
The UDP port that the unit will use to send traps to the notification receiver. By default, the well-known SNMP trap port
(162) is used.
Host name
The IP address or host name of the device that will receive SNMP traps (and/or inform notifications). The unit sends a
Cold Start trap when it starts up.
Community
The community string required to send traps to the notification receiver.
2. Click on the ID to configure each trap receiver.
To Next Page
Loading...
