Akai MPC

308
• Slice: Click this drop-down menu to select what part(s) of the sample will
play:
o All: The entire sample will play.
o Pad: The sample will play from the Pad Start position to the Pad End
position, described below. This also lets you activate Pad Loop.
o Slice 1, 2, 3, etc.: If you have sliced the sample in Chop Mode, you
can select which slice will play when you trigger the pad.
• Dir: Click this drop-down menu to select in which direction the sample will
play:
o Fwd: The sample will play in the normal forward direction.
o Rev: The sample will play in reverse.
• Offset: Click and drag this field up or down to determine a time offset for
the sample's playback. Alternatively, double-click the field and type in a
number.
o Positive values (right of center): When the pad is played, playback
will start immediately but at a later point in the sample specified by
the offset value.
o Negative values (left of center): When the pad is played, playback
will be delayed by the amount specified by the offset value.