Akai MPC User Manual

309
• Pad Start: Click and drag this field up or down to
determine the position (in samples) where the pad's
playback will start. Alternatively, double-click the
field and type in a number. The minimum value is 0,
and the maximum value is the Pad End value.
• Pad End: Click and drag this field up or down to
determine the position (in samples) where the pad's
playback will stop. Alternatively, double-click the
field and type in a number. The minimum value is the
Pad Start value, and the maximum value is the
sample's total length (in samples).
• Pad Loop: Click this box to activate or deactivate
Pad Loop. When activated, you can hold down the
pad to cause that sample to repeat from the Loop
Position (Loop Pos) to the end of the sample.
Release the pad to stop the repeating playback.
Important: For Pad Loop to work, you must set
Sample Play (in the Pad Play Modes section) to
Note On instead of One Shot.
• Loop Pos (position): Click and drag this field up or
down to determine the position (in samples) where
the pad's playback will repeat when Pad Loop is
activated. Alternatively, double-click the field and
type in a number.

Akai MPC Specifications

General

Impedance	16 Ω
Driver unit	50 mm
Magnet type	Neodymium
Ear coupling	Circumaural
Headphone frequency	12 - 24000 Hz
Headphone sensitivity	114 dB
Cable length	2.1 m
Product color	Black, Red, Silver
Wearing style	Head-band
3.5 mm connector	Yes
Connectivity technology	Wired