61
To adjust the volume and panning of a Track using the Plugin Program, click the Track
Mixer tab to enter Track Mixer Mode, and adjust that Track's volume slider or pan knob,
respectively. (If the Track channel strips are not shown, click the Show Tracks icon on
the left edge of the window.)
By default, the volume and pan values will initially appear as ?, indicating the Program is
not sending any volume or pan changes.
The volume and panning of the Plugin Program itself will appear (and can be adjusted) as
normal.
Important:
If you copy a Sequence, the volume and pan values will be copied with that Sequence. If
you move to a new Sequence and put the same Plugin Program on a new Track, though,
these values will appear as ?, as described above.
By default, some plugins do not support MIDI volume and pan. In this case, adjust
volume levels and panning on the Track.
Hardware: To adjust the volume and panning of a Track using the Plugin Program or the Plugin Program
itself:
1. Press Shift + Prog Mix / Track Mix to enter Track Mixer Mode.
2. Use the Cursor Buttons to highlight the Mixer field at the top of the display
3. Use the Data Dial or -/+ buttons to switch between Track and Programs.
• Track will show the information for the Track channel strips.
• Programs will show the information for the Program channel strips.
4. Press F1 (Level) or F2 (Pan) to select the desired tab.
5. Use the Q-Link Knobs to adjust the volume levels or pan settings of your Tracks or Plugin
Programs.
To Next Page
Loading...
Need help?
General
