12 12Software upgrade
Overview
...................................................................................................................................................................................................................................
Purpose
This chapter describes how to upgrade the software of the 1643 AM and 1643 AMS.
Upgrading a system to newer releases
A software upgrade is to be performed when upgrading a system to a newer release.
Important! Upgrading to a newer release must be performed as follows:
• Upgrade to a new release,
• Wait until the network is stable,
• If the upgrade is not Ok, downgrade to old release, activate the old SW again.
• If the upgrade was Ok you can continue and for instance enable new features.
If you enable new features in the new release, and, in the worst case, have to
downgrade to a release that does not support the new features will result in NE
cannot restart.
Contents
Concepts 12-2
Software upgrade 12-3
View software stored in an NE 12-5
View software stored in the NE 12-6
Parameters for viewing the software stored in the NE 12-7
Upgrade NE software 12-8
Loading NE software from CD-ROM to ITM CIT 12-9
Upgrading the software of an NE 12-11
Parameters for upgrading the software of an NE 12-14
...................................................................................................................................................................................................................................
365-312-807R7.2
Issue 4, May 2007
Alcatel-Lucent - Proprietary
See notice on first page
12-1
To Next Page
Loading...
