Rockwell Automation Publication 750-UM006C-EN-P - March 2022 17
Chapter 2
Prepare for Installation
Precautions
ATTENTION: This manual is intended for qualified service personnel
responsible for installing and servicing these devices. You must have
previous experience with, and a basic understanding of: electrical
terminology, configuration procedures, required equipment, and safety
precautions.
ATTENTION: The National Electrical Code (NEC), NFPA79, and any other
governing regional or local code overrules the information in this manual.
Rockwell Automation cannot assume responsibility for the compliance or
proper installation of the On-Machine™ Drive. A hazard of personal injury
and/or equipment damage exists if codes are ignored during installation.
ATTENTION: To avoid electrical shock, open the appropriate upstream
protection (disconnect switch or branch circuit protection) before connecting
and disconnecting cables. To avoid an electric shock hazard, verify that the
voltage on the bus capacitors has entirely discharged before servicing.
ATTENTION:
• Installation, adjustments, putting into service, use, assembly, disassembly,
and maintenance shall be performed by suitably trained personnel in
accordance with applicable code of practice. Failure to do so may lead to
personal injury or death, property damage, or economic loss.
• If this equipment is used in a manner that is not specified by the
manufacturer, the protection that is provided by the equipment, may be
impaired.
To Next Page
Loading...
Need help?
General
