Rockwell Automation Publication 750-UM006C-EN-P - March 2022 95
Configure and Start Up the Drive Chapter 4
After the parameters have loaded, the view changes back the Overview
Dialog box. Notice in the example, that the yellow triangle has
disappeared.
Put the Logix Controller Into Run Mode
1. Use the Controller Status pull-down menu to put the Logix controller
into Run mode.
2. Click Yes when prompted to change controller mode to Remote Run.
TIP If the drive does not come online, see Troubleshooting Going Online on
page 185 in the Troubleshooting chapter of this manual.
To Next Page
Loading...
