94 Rockwell Automation Publication 750-UM006C-EN-P - March 2022
Chapter 4 Configure and Start Up the Drive
Because the original startup for the drive is conducted offline, there is a
mismatch of information between the project and the physical drive.
2. Check Use Project for all applicable items. Click Continue.
The Logix Designer application loads the drive parameters from the
project to the drive.
3. When notified that a reset is required, Click OK.
TIP If you receive a connection error, click Retry. When this error occurs, you are
required to repeat steps 1
…3 of this section. If the problem continues after
a couple of attempts, go to the Troubleshooting
chapter.
To Next Page
Loading...
