Rockwell Automation Publication 750-UM006C-EN-P - March 2022 69
Configure and Start Up the Drive Chapter 4
5. Then click Yes to proceed.
Safety Configuration for SSM and S4
TIP The steps that follow are a result of the sample configuration that
was selected. Refer to PowerFlex 755/755T Integrated Safety
Functions Option Module, publication 750-UM005
for additional
information.
IMPORTANT Only reset ownership if your drive safety card was previously owned by a
different controller.
Safety configuration for the S3 card can only be done when online, refer to
section Create a Safety Program to Control the Drive Safety Circuits
for more
information.
IMPORTANT If configuring the system for Network-Integrated Safe Torque Off (S3), DO
NOT complete this section.
To Next Page
Loading...
