Rockwell Automation Publication 750-UM006C-EN-P - March 2022 81
Configure and Start Up the Drive Chapter 4
You could also not assign it to this function, but choose to read its status
by using the Logix controller via Datalink out, and determine what
action to take when it opens. This action could be to shut down,
complete machine index, then shut down, and so on. See the On-
Machine electrical schematics for more information.
17. Click Next.
18. On the Digital Output steps, click the ellipsis and use the pull-down
menus to configure the output.
ATTENTION: Digital Relay out 0 and Transistor Out 0 are both wired to
control the motor brake contactor. Their proper configuration is critical for
the motor brake control coordination. See the electrical schematics for the
brake wiring details. Failure to follow proper wiring will cause a break
malfunction and will result in equipment damage.
To Next Page
Loading...
Need help?
General
