Rockwell Automation Publication 750-UM006C-EN-P - March 2022 9
Preface
PowerFlex 755 Drive Embedded EtherNet/IP
Adapter User Manual, publication 750COM-UM001
This manual provides information about the EtherNet/IP
adapter that is embedded on the main control board in
PowerFlex® 755 drives, and how to use it for network
communication.
PowerFlex 750-Series Configuration with
Permanent Magnet Motors Application,
publication 750-AT004
This document contains methodologies for the proper test
and setup of PM motors with the PowerFlex 755 drive, using
PM flux vector (FV) mode, and the PowerFlex 750-Series
drives using iPM FV mode.
PowerFlex 750-Series AC Drives Installation
Instructions, publication 750-IN001
This document explains the basic steps for mechanical
installation and for connecting incoming power, the motor,
and basic I/O to the PowerFlex 750-Series Adjustable
Frequency AC drive.
PowerFlex 755 On-Machine Drive Packing
Instructions, publication 750-PC004
This document contains a high level view of the installation
and unpacking instructions for the PowerFlex 755 On-
Machine Drive.
PowerFlex 750-Series Drive Programming Manual,
publication 750-PM001
Provides detailed information on:
• I/O, control, and feedback options
• Parameters and programming
• Faults, alarms, and troubleshooting
PowerFlex 750-Series AC Drives Quick Start,
publication 750-QS001
This Quick Start publication is designed to guide you through
the 6 BASIC STEPS that are required to startup your PowerFlex
750-Series AC drive for the first time for simple applications.
PowerFlex 750-Series AC Drives Technical Data,
publication 750-TD001
Provides detailed information on:
• Drive specifications
• Option specifications
• Fuse and circuit breaker ratings
PowerFlex 755/755T Integrated Safety - Safe
Torque Off Option Module (S3),
publication 750-UM004
These publications provide detailed information on how to
install, configure, and operate the 750-Series safety option
modules.
PowerFlex 755/755T Integrated Safety Functions
Option Module (S4), publication 750-UM005
EtherNet/IP Network Configuration User Manual,
publication ENET-UM006
This manual describes how to use EtherNet/IP
communication modules in Logix 5000 control systems.
Integrated Motion on the EtherNet/IP Network:
Configuration and Startup,
publication MOTION-UM003
Configure an integrated motion on the EtherNet/IP network
application and startup your motion solution with a Logix
controller-based system.
Motion System Tuning Application Techniques,
publication MOTION-AT005
The purpose of this publication is to assist you in tuning a
Kinetix drive system. This document is intended for motion
control users with novice to advanced skill levels that are
familiar with the following:
• Kinetix servo drives
• Servos or EtherNet/IP communication
• Use of the Logix Designer application to create a motion
axis
• Understanding how control loops work in motion control
applications
Each component of the control structure is described in detail
and out-of-box tuning, autotuning, and manual tuning
techniques are presented.
Resource Description
To Next Page
Loading...
