Allied Telesis AT-TQ5403 User Manual

AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
123
System Time Displays the date and time. To set the date and
time, refer to “Manually Setting the Date and
Time” on page 41 or “Setting the Date and Time
with the Network Time Protocol (NTP)” on
page 38.
Uptime Displays the number of hours, minutes, and
seconds that have elapsed since the unit was
last reset or powered on.
Free Memory Displays the amount of free memory in the
access point, as follows:
- The first value is the total amount of unused
memory, in KB.
- The second value is the total amount of
memory, in KB.
- The last number in parentheses is the
percentage of total memory that is free.
MAC Address Displays the MAC address of the access point
and radio 1. Radios 2 and 3 have different MAC
addresses. You cannot change the MAC
addresses.
IP Address Displays the IP address of the access point. To
set this value, refer to “Assigning a Dynamic IP
Address from a DHCP Server” on page 32 or
“Assigning a Static IP Address to the Access
Point” on page 35.
Subnet Mask Displays the subnet mask. To set this value, refer
to “Assigning a Dynamic IP Address from a
DHCP Server” on page 32 or “Assigning a Static
IP Address to the Access Point” on page 35.
Default Gateway Displays the default gateway address. The
default gateway is an IP address of an interface
on a router or other Layer 3 routing device. It
specifies the first hop to reaching the subnets or
networks where your management devices, such
as management workstations and syslog
servers, reside. The access point can have only
one default gateway. To set this value, refer to
“Assigning a Dynamic IP Address from a DHCP
Server” on page 32 or “Assigning a Static IP
Address to the Access Point” on page 35.
Table 23. System Window (Continued)
Item Name Description

Allied Telesis AT-TQ5403 Specifications

General

Brand	Allied Telesis
Model	AT-TQ5403
Category	Wireless Access Point
Language	English