Allied Telesis AT-TQ5403 User Manual

AT-TQ5403 and AT-TQm5403 Access Point User’s Guide
73
Configuring Basic VAP Parameters
To configure basic VAP settings, perform the following procedure:
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1, Radio2, or Radio3 from the sub-menu. The default is
Radio1. You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0. You can configure only one VAP at a time.
4. Select the Virtual Access Point tab. This is the default tab. The
example in Figure 19 shows the settings for VAP0 on Radio1.
Figure 19. Virtual Access Point Tab
5. Configure the parameters by referring to Table 12.
Table 12. Virtual Access Point Tab
Field Description
Status Enable or disable the VAP. Here are the
guidelines.
- A disabled VAP does not forward any ingress
or egress traffic.
- The default setting for VAP0 is enabled.

Allied Telesis AT-TQ5403 Specifications

General

Brand	Allied Telesis
Model	AT-TQ5403
Category	Wireless Access Point
Language	English