AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
19
Enable or disable the Reset button
SNMPv1 and v2c You can use SNMPv1 or SNMPv2 to view the parameter settings of the
devices. The MIB is available from the Allied Telesis web site. For
instructions on how to configure the unit for SNMP, refer to “Configuring
SNMPv1 and v2c” on page 43 and “Configuring SNMP Traps” on page 47.
You cannot use SNMP to change the parameter settings on the
access points.
The access points do not support SNMPv3 or the AT-UWC Wireless
LAN Controller.
To Next Page
Loading...
