Allied Telesis AT-TQ5403 - Configuring VAP Security; No Security; Figure 20: None Selection in the VAP Security Tab

Chapter 5: Virtual Access Points
76
Configuring VAP Security
The procedures for configuring VAP security is provided in the following
sections:
 “No Security” on page 76
 “Static WEP” on page 77
 “WPA Personal (Pre-Shared Key)” on page 78
 “WPA Enterprise” on page 81
No Security VAPs not requiring any security can be set to the None security level.
Wireless clients do not use encryption or authentication to access VAPs
with no security. This is the default setting.
To configure a VAP for no security, perform the following procedure:
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1, Radio2, or Radio3 from the sub-menu. The default is
Radio1. You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0. You can configure only one VAP at a time.
4. Select the Security tab.
5. Select None from the Mode pull-down menu. This is the default
setting. Refer to Figure 20.
Figure 20. None Selection in the VAP Security Tab
6. Click the SAVE & APPLY button to save and update the configuration.