AT-TQ5403 and AT-TQm5403 Access Point User’s Guide
81
WPA Enterprise To configure a VAP for WPA Enterprise security, perform the following
procedure:
WPA Enterprise is not available on VAP0 when it is the parent or
child of a WDS bridge.
1. Select Settings > VAP / Security from the main menu.
2. Select Radio1, Radio2, or Radio3 from the sub-menu. The default is
Radio1. You can configure only one radio at a time.
3. Select a VAP to configure from the next sub-menu. The default is
VAP0. You can configure only one VAP at a time.
4. Select the Security tab.
5. Select WPA Enterprise from the Mode pull-down menu. Refer to
Figure 23.
Figure 23. WPA Enterprise Tab
To Next Page
Loading...
