Allied Telesis AT-TQ5403 - Starting a Management Session; Figure 1: Log on Window

AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
23
Starting a Management Session
This section explains how to start a management session on the access
point from your management workstation, using a web browser. The
procedure assumes that the access point has already been assigned an IP
address, either manually or from a DHCP server.
Note
If the access point is using its default address 192.168.1.230, refer
to “Starting the First Management Session” on page 20 for
instructions.
To start a management session on the access point, perform the following
procedure:
1. Open the web browser on your management workstation.
2. Enter the IP address of the access point in the URL field of the web
browser.
Note
Precede the IP address with HTTPS:// if the access point is already
configured for HTTPS management. The default is HTTP
management.
You should now see the log on window in Figure 1.
Figure 1. Log On Window