AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
47
Configuring SNMP Traps
To configure the access point to transmit SNMP traps, perform the
following procedure:
1. Select Settings > System from the main menu.
2. Select SNMP from the sub-menu.
3. Click the Trap Settings tab. Refer to Figure 10.
Figure 10. Trap Settings Window
The Status parameter has to be set to Enabled in the Agent Settings
tab before you can configure the parameters in this window. Refer to
“Configuring SNMPv1 and v2c” on page 43.
4. Configure the fields by referring to Table 7 on page 48.
To Next Page
Loading...
