Chapter 2: Basic Settings
36
Table 3. Network Static IP Selection Window
Item Name Description
Host Name Enter a host name for the access point. Here
are the guidelines:
- The host name can be from 1 to 63
alphanumeric characters.
- The hostname cannot contain spaces or
any special characters, except hyphens.
- The first or last character cannot be a
hyphen.
- The access point can have only one
hostname.
- The default is AT-TQ5403 or
AT-TQm5403.
Connection Type Select Static IP.
Static IP Address Enter the new IP address for the access
point. The device can have only one IP
address. The default is 192.168.1.230.
Subnet Mask Enter the subnet mask for the IP address.
The default is 255.255.255.0.
Default Gateway Enter the default gateway address for the
unit. The default is 192.168.1.254.
The default gateway is an IP address of an
interface on a router or other Layer 3 routing
device. It specifies the first hop to reaching
the subnets or networks where your
management devices, such as management
workstations and syslog servers, reside. The
access point can have only one default
gateway and the network portion of the
address must be the same as the IP address
entered in step 3.
You have to assign a default gateway to the
access point. If your network does not have
a default gateway or you do not want to
assign one to the access point at this time,
enter an unused IP address of the same
network as the IP address.
To Next Page
Loading...
Need help?
General
