Chapter 6: Quality of Service
92
Introduction to Quality of Service
Each radio in the access point has four QoS egress queues and four
ingress queues. There are parameters that control the manner in which
the device stores and handles packets in the queues. You should not
adjust these values unless you are familiar with QoS. The parameters are
divided into the following two groups:
Access Point (AP) Enhanced Distributed Channel Access (EDCA)
Parameters table contains parameters that control the four queues
that store egress traffic the access point transmits to the wireless
clients.
The Station Enhanced Distributed Channel Access (EDCA)
Parameters table controls the four queues that store ingress traffic
the access point receives from the clients.
To configure the QoS settings for the radios, perform the following
procedure.
1. Select Settings > QoS from the main menu.
2. Select Radio1, Radio2, or Radio3 from the sub-menu. You can
configure only one radio at a time. Refer to Figure 27 on page 93.
3. Configure the QoS parameters by referring to the following sections:
“Configuring QoS Basic Settings” on page 94
“Configuring AP EDCA Parameters” on page 95
“Configuring Station EDCA Parameters” on page 98
4. Click the SAVE & APPLY button to save and update your
configuration.