Allied Telesis AT-TQ5403 User Manual

AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
43
Configuring SNMPv1 and v2c
You can use SNMPv1 and v2c to view the settings and client statistics on
the access point, and receive traps. Here are the guidelines:
 You cannot use SNMP to change the settings on the access point.
 The access point does not support SNMPv3.
 The access point has one read-only community string.
 The unit must have an IP address for SNMP management. For
instructions, refer to “Assigning a Static IP Address to the Access
Point” on page 35 or “Assigning a Dynamic IP Address from a
DHCP Server” on page 32.
To enable or disable SNMP, perform the following procedure:
1. Select Settings > System from the main menu.
2. Select SNMP from the sub-menu.
3. Click the Agent Settings tab. This is the default tab. Refer to Figure 9.
Figure 9. SNMP Agent Settings Window
4. Configure the fields by referring to Table 6 on page 44.

Allied Telesis AT-TQ5403 Specifications

General

Brand	Allied Telesis
Model	AT-TQ5403
Category	Wireless Access Point
Language	English