Allied Telesis AT-TQ5403 User Manual

AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
61
5. Click the SAVE & APPLY button to save and update the configuration.
Bandwidth
(Radio1)
Select the bandwidth for Radio1 from the
pull-down menu. The selections for IEEE 802.11n
are listed here:
- 20 MHz. This is the default setting.
- 40 MHz
For IEEE 802.11n modes, channel width can be
40 MHz-wide or the legacy 20 MHz-wide. The 40
MHz-wide channel allows for higher data rates,
but reduces the number of available channels for
other wireless devices.
The only bandwidth for IEEE 802.11b/g is 20
MHz.
Bandwidth
(Radio2 or
Radio3)
Select the bandwidth for Radio2 or Radio3 from
the pull-down menu. The available bandwidths for
IEEE 802.11n/ac are listed here:
- 20 MHz. This is the default setting.
- 40 MHz
- 80 MHz
The only bandwidth for IEEE 802.11a is 20 MHz.
Auto Channel
Selection
Select the channels that the radio can chose from
when the Channel parameter is set to Auto. Here
are the guidelines.
- A channel is enabled when its check box has a
check and disabled when the check box is
empty.
- The available channels vary by radio, mode,
bandwidth, and country.
- The default is all available channels are
enabled.
- This parameter is disabled when the channel is
selected manually.
Tx Power Select the strength of the radio transmitter. The
selections are Max (maximum), High, Middle,
Low, Min (minimum). The default is Max.
Table 9. Basic Radio Settings Window (Continued)
Field Description

Allied Telesis AT-TQ5403 Specifications

General

Brand	Allied Telesis
Model	AT-TQ5403
Category	Wireless Access Point
Language	English