AT-TQ5403 and AT-TQm5403 Access Points User’s Guide
97
Max. Burst Specifies the maximum burst length (in seconds)
for packet bursts on the wireless network. A
packet burst is a collection of multiple frames
transmitted without header information. The
decreased overhead results in higher throughput
and better performance. Here are the guidelines:
- This is an AP EDCA parameter only and as
such applies only to egress traffic from the
access point to the wireless clients.
- The factory defaults are 1.5 for Data 0, 3.0 for
Data 1, and 0 for Data 2 and Data 3.
- The range is 0.0 to 8.1 seconds.
Table 19. QoS Window - AP EDCA Parameters (Continued)
Parameter Description
To Next Page
Loading...
