Allied Telesis x530 Series - Page 145

x530 Series Installation Guide for Virtual Chassis Stacking
145
6
Return to the Global Configuration mode.
awplus(config-if)# exit
7
Return to the Privileged Exec mode.
awplus(config)# exit
8
Enter the WRITE command to save your change.
awplus# write
Building configuration ...
[OK]
9 Power off the switches of the stack.
10 Cable the new SFP+ ports on the trunk.
11 Power on the switches.
12 Wait three minutes for the switches to start the AlliedWare Plus software and form the
stack.
13 Repeat “Verifying the Stack” on page 143.
Table 23. Adding SFP+ Ports to the Default SFP+ Trunk (Continued)
Step Description and Command