134
ML-2050A/2051A/2150A
4. Commands
Reading the Timesharing Unit Status
The command (code: RM) to read the timesharing unit status is explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
SH1/SH0 Schedule No. (SH1 = tens digit, SH0 = units digit)
cnt
Control method
0: Control by control panel
1: Control by external input/output signals (Output schedules are set on
the control panel.)
2: Control by external communication control
3: Maintenance mode
4: (Missing number)
5: Control by external input/output signals (Output schedules are set on
the personal computer.)
m1 Timesharing unit 1 (0: OFF 1: ON)
m2 Timesharing unit 2 (0: OFF 1: ON)
m3 Timesharing unit 3 (0: OFF 1: ON)
m4 Unused (xed to 0)
m5 Unused (xed to 0)
Starting a Laser Light Output
The command (code: $0) to start a laser light output is explained below.
CH1/CH0 Equipment No. (CH1 = tens digit, CH0 = units digit)
To Next Page
Loading...
