Amada ML-2050A-CE - Chapter 1 How to Perform Maintenance; Note; Maintenance Parts and Standard Intervals of Inspection;Replacement

1. Maintenance Parts and Standard Intervals of Inspection/Replacement
145
ML-2050A/2051A/2150A
Chapter 1 How to Perform Maintenance
Introduction Part
Installation and Preparation Part
Operating Part Maintenance Part Appendixes
Chapter 1
●
How to Perform Maintenance
NOTE
Before starting maintenance, read the following items and take extreme care.
WARNING
■ Before starting maintenance operations, be sure to turn OFF the power supply.
If a high voltage is already applied, turn OFF the power supply and then start these
operations at least in 5 minutes.
■ Turning ON the power supply for an operation check during maintenance puts the
YAG Laser in oscillation. Take extreme care about it.
■ The operator and those who may receive YAG laser light during maintenance must
put on protective glasses.
CAUTION
■ Use our genuine maintenance parts.
■ For defect caused by non-genuine maintenance parts or use of non-genuine
maintenance parts, the repair is charged even if it is still within the maintenance
contract period or the warranty period.
1. Maintenance Parts and Standard Intervals of
Inspection/Replacement
The performance of maintenance parts will be gradually deteriorated while they
are used, and they may have to be repaired or replaced. Perform inspection
periodically referring to the following table.
⇒
The model numbers of maintenance parts are subject to change without notice.
For the latest parts information, contact a nearest sales o󰀩ce.
Part name Model No.
Operation
interval
(standard) (*1)
Contents of
operation
(*2)
Flashlamp MLD-0902
1 million shots
(*3)
Replace
Ion-exchange resin rell MLF-0020 6 months Replace
Cartridge (Ion-exchanger)
(With one bag of ion-exchange resin)
MLF-0024-00 3 years Replace
Maintenance Part