Amada ML-2050A-CE - Preparing Cooling Water

42
ML-2050A/2051A/2150A
2. Preparing Cooling Water
2. Preparing Cooling Water
CAUTION
Use deionized water or puried water for cooling water. Using tap water, industrial
water, ground water, or ultra pure water (Resistivity: 16 MΩ-cm or more) causes
corrosion or clogging, resulting in a failure.
Item required
Cooling water (6 liters), water feed pump
Operating Procedure
(1) Open the front door and remove the lid of the cooling water tank.
(2) Take out the oating panel in the tank.
⇒
Take care not to attach dirt onto the oating panel.
(3) Feed cooling water up to the line under the water level label "HIGH" by using the
attached water feed pump.
⇒
Use the water feed pump only for cooling water and do not use other uses
including kerosene.
(4) Float the oating panel on the water and install the lid of the cooling water tank
as before.
⇒
The oating panel can be repeatedly used. When it is stained, wash it lightly in
tap water with a soft sponge and lastly rinse it in deionized water or puried water
for use.
⇒
When the cooler is operated for the rst time after water feeding, the water level
may a little lower. In this case, replenish cooling water again. Before feeding
cooling water, be sure to take out the oating panel.
Status where the front door of the main unit is opened
UPPER LIMIT
LOWER LIMIT
P-1518
Lid
Water level label
Floating panel
Ion-exchanger
Cooling water tank