Anilam Wizard 900 - Page 118

112
Datum Key (N/A for 900, Lathe Mode) (Continued)
9. Press the axis key for the X-axis.
10. Press to enter the X-axis value,
2 in. (50.8 mm).
11. Press the axis key for the Y-axis.
12. Press to enter the Y-axis value,
1 in. (25.4 mm).
13. Press to set datum 2.
To enter datum 3:
14. Press
15. Press the axis key for the X-axis.
16. Press to enter the X-axis value, 3.5
in. (88.9 mm).
17. Press the axis key for the Y-axis.
18. Press to enter the Y-axis value, 1.5
in. (38.1 mm).
19. Press to set datum 3.